Type 1 Ho-Ki
General Historical Information
Place of origin Japan
Category Armoured Personnel Carrier
Debut in FHSW Debut in FH mod
Speed 42 km/h
General Ingame Information
Used by Japan
Crew in‑game 2
Special abilities Artillery Tractor
Can drop Nambu machiengun on tripod.
Seat 2 Nambu machinegun.
Seat 3 Passenger Seat
Seat 4 Passenger Seat
Seat 5 Passenger Seat
Seat 6 Passenger Seat
Transporting artillery 47 mm Type 1
EHP 10cm Cannon
Type 96 15 cm Howitzer
Ammunition limbers (see Picture above)
Historical Picture

The Type 1 Ho-Ki was developed in 1942 as a result of a request from the Army for a heavy armored artillery tractor which could also serve as a personnel transport. Production of both tracked and half-track APCs began in 1941, and both versions were confusingly designated “Type 1" (See also Type 1 Ho-Ha half-track). The fully tracked Type 1 Ho-Ki was built by Hino Motors, but only in small quantities. Although the Japanese army had employed mechanized infantry formations in China from the mid-1930s, the general view of field commanders was that armored transports were too slow compared with normal trucks, and were unable to keep up with the speed necessary for contemporary infantry tactics. Furthermore the priorities of Japanese military production were on combat aircraft and warships, and other offensive weaponry and most experiemental APC designs never made it past the prototype stage. By the time the Type 1 Ho-Ki actually entered mass production in 1944, raw materials were in very short supply, and much of Japan's industrial infrastructure had been destroyed by American bombing. The total number produced is unknown. The Type 1 Ho-Ki had an unusual silhouette, in that the driver's cab did not reach across the front of the hull, but stopped short about mid-way across the center line. Only one driver was required (although two were typically employed), who manipulated the left and right movement of the tracks via a pair of tiny steering wheels. Transport capacity was about thirteen men, and the maximum armor thickness was 6 mm. As the Type 1 Ho-Ki had been designed to pull artillery as well as to carry infantry, it had no rear exit hatch, it was felt that the towed weapon might interfere with the rapid exit of any onboard riflemen. Entry and exit of troops was thus accomplished from the left (driver's) side via three doors mounted side by side. The engine, which was located at the right front of the body, was a 6-cylinder, in-line, valve-in-head, air-cooled diesel. The Type 1 Ho-Ki was not normally armed, but provision was made to mount a machine gun to the rear of the driver. The Type 92 Heavy Machine Gun carried by Japanese infantry squads could be mounted in this position. Although it was an APC, it was often called a halftrack.